Seed Hawk Raven 2012 - Manual (Page 107)

5
Manual No. 016-3001-003 95
Using the Seed Hawk® Viper Pro System
Alarms
If the Viper Pro is configured as the CANbus controller, the field computer will display a specific warning
prompt for any configured alarm conditions encountered during an active job. These prompts will contain
information to assist the machine operator address the alarm condition.
In addition to the warning boxes, the Product Control area on the main screen will display a yellow ‘warning’
indicator instead of the green ‘thumbs up’ symbol and a Current Alarms button will be displayed at the bottom
of the CAN Controller Status screen if an alarm condition is active.
Note:
Off rate and low limit alarms will automatically clear once the condition has corrected itself. All
other alarms will need to be cleared by touching the OK button on the warning prompt.
Addressing Alarm Conditions
To view any current alarms detected on the CANbus system from the Viper Pro main screen:
1. Touch the Product Control area at the bottom of the screen.
2. Select the Current Alarms button at the bottom of the CAN Controller Status screen. The Current CAN
Node Alarms screen displays: