Existing jobs, Viewing an existing job, Adding to an existing job – Seed Hawk Raven 2012 User Manual
Page 91
5
Manual No. 016-3001-003
79
Using the Seed Hawk® Viper Pro System
Existing Jobs
Jobs previously created on the Viper Pro may be reopened to complete report information or to resume a field
operation. The following options are available when opening an existing job file:
•
View the existing job
•
Add to the existing job
Viewing an Existing Job
When viewing an existing job, application information may not be added. Use this feature to view job
information without editing or modifying any application data.
1.
Press Menu, then Start Job, From File, and View Only. The Select Existing Job File screen opens.
2.
Select a job from the list and press OK. Viper opens the job.
3.
Press Menu, Close Job to close the job.
Adding to an Existing Job
Previously closed jobs may be reopened and the application or coverage map may be modified by adding to
the application. This feature is useful if a job has been closed because of a change in weather conditions, lack
of materials, etc.
Note:
When re-opening an existing job, Viper will automatically pause the application. To add to the job,
un-pause the job before starting product application to allow the Viper to modify the job
information.
The original data is used when adding to the job file. Make sure that all files created in or used by the existing
job are still available on the Viper Pro field computer and verify that the original machine configuration is the
same as when the job was initially started. These parameters include number of booms, boom widths, boom
offsets, etc.
Note:
The original swath pattern will be used to provide guidance when the existing job is restarted. Due
to shifts in satellite geometry between active job sessions, the operator should perform a swath
recalibration to update the guidance information and swath position for the actual machine
location.
1.
Select Menu, then Start Job, From File, and Add to Job. The Select Existing Job File screen displays.
2.
Select the existing job to open from the list and press OK. Viper loads the job information.
3.
Press Menu, and Cont. Job to add to the job.