Seed Hawk Raven 2012 - Manual (Page 74)

Chapter 5
62 Seed Hawk® Viper Pro™ Installation & Operation Manual
SBR (Seed Between Rows)
Switch the seed between rows feature on or off.
RWS (Rear Wheel Steering)
Toggle the rear wheel steering feature on or off.
Note:
This feature is currently not available on the Seed Hawk Viper Pro system.
Product Switches
Toggle product control manually by placing the product switch in the ON or MAN position. To allow the Viper
Pro to automatically adjust product rates, toggle the product switch to the AUTO position.
INC/DEC Switch
Use the INC/DEC switch to quickly adjust the application rate of enabled products (see the Seed Hawk
Installation & Operation Manual to set and enable rate bump (+/-) values for specific products. For products in
manual (MAN) mode, hold the switch in the INC or DEC position to manually increase or decrease the actual
application rate. For products in automatic (AUTO) mode and rate bump enabled, hold the switch in the INC or
DEC position to increase or decrease the target application rate by the rate bump value.
Overview of Job Files and Features
The Viper Pro uses jobs and job files to automatically log data in the field during operations using the
application management system. During an active job, the Viper Pro collects the following information:
• Target rate (min and max) for each enabled product
• Coverage area and area within a field boundary
• Volume of product applied
• Prescription map information (if applicable)
The job file also collects GPS location information to display the above information in an as-applied or
coverage map of the field or areas where coverage or product application has been completed. When
application or coverage has been completed for a field, the as-applied map may be transferred to a home or
office computer to archive the job data or to create customer application reports.
Note:
A DGPS receiver is not required to control product rates as long as a wheel or radar speed sensor
is connected to the Viper Pro. An as-applied or coverage map will not be created and an
application report will not be available when operating without DGPS information being input into
the Viper Pro.
A DGPS receiver is required to allow the Viper Pro to control product rate based upon GPS speed,
log as-applied or coverage map information or to provide swath guidance. Refer to the GPS Status
Screens section on page 140 for details on connecting a DGPS receiver to the Viper Pro.