Seed Hawk Raven 2012 - Manual (Page 140)

Chapter 8
128 Seed Hawk® Viper Pro™ Installation & Operation Manual
Display Smoothing. Enable the display smoothing feature to allow the field computer to smooth the rate
displayed during product applications. With this feature enabled, the actual rate (R
A
) in the rates area will
display the target rate (R
T
) as long as the actual monitored application rate remains within ±10% of the target
rate. The actual rate shown on the main screen will display the actual monitored rate if the application system
does not reach the target rate dead band (±10%) within 10 seconds.
Disable the display smoothing feature to monitor the actual application rate at all times.
Note:
The display smoothing feature is only active for products in Automatic control mode.
Feature Settings Area for Products 4-5
The information displayed in the Feature Settings area is an overview of the alarm and feature settings for the
selected product control node. For product nodes or control channels 1 through 3, the following settings will be
displayed in the Feature Settings area:
Note:
The following sections offer descriptions of the various options and settings used with products 4
and 5. For descriptions of the settings used with products 1 through 3, see the Feature Settings
Area for Products 1-3 section on page 125.
To modify the feature or alarm settings for the above features, touch within the feature settings area on the
CAN Controller Status screen.
Note:
Before changing any of the feature or alarm settings, be sure to select the correct product node or
control channel by touching the corresponding radio button displayed at the top of the feature
settings area.
• Dual Flow % • Flow/Shaft Alarm • Display Smoothing
• Off Rate % • Vacuum/Bin Alarm • Agitator
• Low Tank • Decimal Shift • Ratio Rate
• Low Limit • Zero Speed Shutoff
Status Screen Example
(Products 4-5)