Seed Hawk Raven 2012 - Manual (Page 87)

5
Manual No. 016-3001-003 75
Using the Seed Hawk® Viper Pro System
8. Press Next. If Product Application was selected, the Product Selection screen displays.
CAN nodes are controlled in a sequential manner and each single product node provides one product
control channel. The operator may only enable the number of control channels currently available on the
machine when setting up a new job. It is recommended to select the maximum number of product control
channels available on the machine each time a new job is started to allow the most flexibility during product
application.
For Example:
If product will be applied from a single tank, but the tank contains a mixture of three products, the
operator must enable one control channel to control rate for the mixture.
To only apply products associated with control nodes 4 and 5, the operator must select 5 on the
Product Selection screen during job setup. If only product nodes 1 and 2 in a 5 product CANbus
system will be used during a job, it is still recommended to select 5 products to allow the operator
to enable or disable remaining product nodes during the job as necessary without beginning a new
job. This also allows the job to be re-opened at a later date to apply additional products using other
product nodes.
9. Enter the number of products which will be applied during the job application.
10. Select the Enable Product Chaining option to link bins or tanks together in sequence during the job.
Enabling Product Chaining
1. Select the ‘Enable Product Chaining’ option on the Product Selection screen.
Note:
If only one product node is detected on the CANbus, this option will not appear on the screen and
the following screens will not be displayed.
The product chaining feature is not available with ground drive Base systems.
Two or more products must be selected in order to enable the product chaining feature.