Seed Hawk Raven 2012 - Manual (Page 201)

10
Manual No. 016-3001-003 189
Remote Calibration Console
Troubleshooting
Error Messages
Issue Possible Cause Solution
Remote tank
console will not
power on • Seed Hawk Viper
Pro not powered on • Power on the Seed Hawk Viper Pro and access the
Program Selection Menu screen.
• Power not provided
to remote tank
console • Check and reconnect 6-pin Deutsch connector.
• Check and reconnect 4-pin round connector on the back
of the remote tank console.
• Check and reconnect air cart cable to chassis
connection.
Meter rollers do
not turn when
priming or
calibrating. • Hydraulics to air cart
are not powered on. • Turn hydraulics to air cart on and check pressure.
• Verify there is no debris or blockages in the hydraulic
circuit.
Issue Possible Cause Solution
Check air cart
node or CAN
communication • Power/ground issue
with air cart node(s). • Check the power and ground connections on air cart
nodes.
• Check CANbus system connections and reconnect
nodes.
No nodes have
been found. Verify
power to node
and CAN
connection • Nodes not powered
or faulty logic power
connection • Check CANbus system connections and reconnect
nodes.
• CAN nodes not
connected to
controller. • Verify hitch connections and check CANbus system
connections.
Can not calibrate,
note enough
meter revolutions.
Press any key • Valve PWM output
insufficient for
system
measurement • Increase PWM output during priming procedure.
• Verify PWM or PWM close valve type is selected for the
selected product(s).
• Be sure the min and max PW values are programmed
correctly. Refer to the PWM Calibration Assistance
section on page 241 for more information.