Seed Hawk Raven 2012 - Manual (Page 45)

4
Manual No. 016-3001-003 33
Initial Set Up and Navigation
5. The first three nodes in a Seed Hawk system are automatically set to Gran 4 (Air Cart System).
Note:
Control channels 4 or 5 for liquid or anhydrous ammonia products may be set for Liquid, Gran 1
(single bed, single encoder), Gran 2 (dual bed, single encoder) or Gran 3 (dual bed, dual
encoder).
Depending upon the product node connected to the system, options for spinner or injection control
may also be available. If the control system detects an injection node, the application types will be
limited to liquid injection or granular injection. Refer to the Raven Viper Pro Installation and
Operation Manual for more information about spinner control operations.
6. Repeat the above process for remaining product nodes or control channels as necessary.
7. Touch OK to save the currently displayed settings and return to the CAN Controller Status screen.
Rate Cal(s)
1. Touch within the Product Control area at the bottom of the main screen.
2. Make sure that Node 1 is selected on the CAN Controller Status screen and touch within the second data
display, or Product Control Settings area, on the CAN Controller Status screen.
Status Screen Example
(Products 1-3)
Status Screen Example
(Products 4-5)