Installation, start up & registration, Overview of the installation process – Seed Hawk Raven 2012 User Manual
Page 23
CHAPTER
3
Manual No. 016-3001-003
11
Chapter 3
Installation, Start Up
& Registration
Overview of the Installation Process
The following sections are intended as an overview of the Viper Pro installation process. These instructions
cover basic installation of the Viper Pro field computer and supplied components and cabling.
Note:
For instructions on installing additional hardware with the Viper Pro, refer to instructions provided
with the additional or optional component(s). For additional system diagrams, see Appendix A,
System Diagrams.
Basic installation of the Viper Pro system is as follows:
1.
Review Kit contents
2.
Mounting the Viper Pro field computer
3.
Mounting the DGPS receiver and antenna
4.
Route and connect sectional control console cable
5.
Route and connect sectional control vehicle power/CAN cable
6.
Connect any optional CAN or GPS components
The following components will be installed on the tractor to be used with the Seed Hawk
®
air cart system.
Before proceeding with the installation of the Viper Pro system, review this list.