Seed Hawk Raven 2012 - Manual (Page 71)

4
Manual No. 016-3001-003 59
Initial Set Up and Navigation
CAN Controller Status
While operating in Seed Hawk and controlling seeding operations over a CAN network, the current control
settings for each product node or control channel are displayed on the CAN Controller Status screen.
The following information areas display on the CAN Controller Status screen:
• The Section Cals Area displays an overview of the current boom section widths and mapped display
characters. Review the Initial Set Up section on page 29 for details on configuring the boom or implement.
Refer to Section Assignments section on page 122 for more information on assigning products to specific
sections.
• The Miscellaneous Settings Area displays an overview of current selections for the display units, speed
sensor and current vehicle speed, etc. Information about the CANbus nodes is also accessible by touching
within this area. Refer to the Miscellaneous Settings Area section on page 123 for more information.
• The Fan RPM displays the current fan speeds for fans 1 and 2 supplying air flow for the products in the air
cart bins. Refer to the Fan Cal section on page 38 for details on calibrating the air cart fans.
• Use the Node/Channel selection to view the current settings for a specific product node or control channel.
When modifying settings, be sure to select the appropriate product node or control channel before changing
any settings.
• The Feature Settings Area displays an overview of the currently programmed alarm settings and features
for the selected product node or control channel. Refer to the Feature Settings Area for Products 1-3
section on page 125 or the Feature Settings Area for Products 4-5 section on page 128 for more
information on available features accessible through the feature settings area.
• The Product Application Settings Area displays the current calibration and application settings for the
selected product node or control channel. Refer to the Product Control Settings Area for Products 1-3
section on page 132 or the Product Control Settings Area for Products 4-5 section on page 135 for more
information on the settings required for controlling rate of product application.
• The pressure registered by an optional transducer is displayed in the Pressures Area. Touch within the
pressures area to calibrate the pressure transducer. Refer to the Dual Pressure Area section on page 139
for more information.
• The Application Area displays the selected application type and control valve selection for the selected
product node or control channel. Refer to the Application and Control Valve Type(s) section on page 32 for
more information on the control valve and application type settings.
Section Cals
Area
Features
Settings Area
Product
Application
Settings Area
Pressure Area Application and
Valve Type
Miscellaneous
Settings Area
Tally Registers and
CAN Profiles
Fan RPM
Display
Current Alarms