Seed Hawk Raven 2012 - Manual (Page 42)

Chapter 4
30 Seed Hawk® Viper Pro™ Installation & Operation Manual
Time Zone
1. Touch Menu, Setup, Local, and Time Zone. The Time Zone Setup screen displays.
2. Touch the desired time zone from the list. Use the Up or Down arrows if necessary to display additional
time zones.
3. Select the Auto Adjust for Daylight Savings option to allow Viper to automatically adjust for daylight
savings.
4. Touch OK to save the displayed selections and return to the main screen.
Display Units
Both the display units and units used for configuring CAN nodes may be selected independently on the Viper
Pro. To ensure proper calibration and display of application information and field computer calibration, it is
recommended to set both unit settings to the same measurement system.
Display Units
1. Touch Menu, Setup, Local and Units. The Display Units screen will be displayed.
2. Select English (units displayed in feet, miles, ounces, etc.) or Metric (units displayed in meters, kilometers,
liters, etc.) for unit displays on the Viper Pro.
Configuration Units
1. Touch within the Product Control area at the bottom of the main screen.
2. Touch within the Miscellaneous area in the upper, right corner of the Controller Status screen.
3. Select US to configure settings in English units (gallons, pounds, acres, etc.), Metric to configure settings in
metric units (liters, kilograms, hectares, etc.) or Turf to configure settings using the English measurement
system in units per 1000 square feet.
Note:
If the Turf units are selected on the Miscellaneous Settings screen, it is recommended to set the
display units to English to ensure that any settings or displays are showing units in the same
measurement system.
4. Touch OK if the other settings displayed on the Miscellaneous settings screen are correct or proceed to the
Speed Sensor Type and Cal section on page 31 to continue setting up the Viper Pro.
Product Controller
1. Touch Menu, Setup, Prod. Control. The Select Controller screen will be displayed.
2. Select the appropriate controller setting from the list of available options.
a. If the Viper Pro field computer will be used to control a CANbus control system, verify that the CAN
option is selected.
Note:
If the Viper Pro is set up as the CAN controller, the boom sense/speed node, and at least one
product control node must be programmed to allow the Viper Pro to control application of a product
during a field application.
b. If the Viper Pro will be connected to a separate Raven rate control console via a serial cable, select the
specific rate controller from the list of controller model options.