Backup battery removal and installation, Getting started – Philips V200 User Manual
Page 33
Chapter 4
Getting Started
REF 1057983 A
Respironics V200 Ventilator Operator’s Manual
4-5
Backup Battery Removal and Installation
Required Tool: Philips screwdriver
Remove the backup battery from the internal packaging material and shipping
bag. Do not discard packing materials until the backup battery has been
installed on the ventilator and its operation has been confirmed.
NOTE:
Save the shipping container in case the backup battery has to be returned
to Respironics.
Figure 4-3 illustrates the backup battery assembly.
Figure 4-3: Backup Battery
1. Before the backup battery is installed, disconnect AC power and any
attached equipment. Disconnect the backup battery cable connector
from the rear panel of the ventilator by rotating the connector's collar
nut counterclockwise while pulling back on the connector.