beautypg.com

4 displaying user connecting to system, 5 mac table, Displaying user connecting to system – Siemens S223 User Manual

Page 99: Mac table, Displaying user connecting to

background image

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

A50010-Y3-C150-2-7619 99

The following is an example of tracing packet route sent to 10.2.2.20.

SWITCH# traceroute 10.2.2.20

traceroute to 10.2.2.20 (10.2.2.20), 30 hops max, 38 byte packets

1 10.2.2.20 (10.2.2.20) 0.598 ms 0.418 ms 0.301 ms

SWITCH#

6.3.4 Displaying

User

Connecting to System

To display current users connecting to the system from a remote place or via console in-
terface, use the following command.

Command Mode

Description

where

Enable

Shows current users connecting to the system from a
remote place or via console interface.

The following is an example of displaying if there is any accessing user from remote place.

SWITCH# where

admin at ttyp0 from 10.20.1.32:2196 for 30 minutes 35.56 seconds

admin at ttyS0 from console for 28 minutes 10.90 seconds

SWITCH#

6.3.5 MAC

Table

To display MAC table recorded in specific port, use the following command.

Command Mode

Description

show mac

BRIDGE [PORTS]

Enable

Global
Bridge

Shows MAC table.
BRIDGE: bridge name

The following is an example of displaying MAC table recorded in default.

SWITCH(config)# show mac 1

port mac addr permission in use

==================================================================

eth01 00:0b:5d:98:92:da OK 16.62

eth01 00:14:c2:d9:8a:b5 OK 56.62

eth01 00:01:02:50:d6:b9 OK 72.62

eth01 00:0d:9d:8c:00:ee OK 72.62

eth01 00:15:00:39:4d:2e OK 92.62

eth01 00:0e:e8:8b:24:ae OK 115.48

eth01 00:14:c2:d9:4c:f0 OK 115.48

eth01 00:0b:5d:53:4d:96 OK 124.62

eth01 00:13:20:4b:05:af OK 132.62

eth01 00:0e:e8:f0:b3:63 OK 152.62

(skipped)

SWITCH(config)#

This manual is related to the following products: