Siemens S223 - Manual (Page 355)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 355
The following example shows how to configure the distance with more than 2 options:
• distance ospf external <1-255> inter-area <1-255>
• distance ospf inter-area <1-255> intra-area <1-255>
To make it as a default, use the following command.
Command Mode Description
no distance ospf Router Restores it as the default.
10.2.14 Host Route
OSPF regards routing information of specific host as stub link information. Routing infor-
mation can be assigned to each host which is connected with one router.
To configure the routing information to each host, use the following command.
Command Mode Description
host A.B.C.D area A.B.C.D
host A.B.C.D area A.B.C.D cost <0-65535>
Router
Configures the routing information to
each host.
Command Mode Description
host A.B.C.D area <1-4294967295>
host A.B.C.D area <1-4294967295> cost <0-
65535>
Router
Configures the routing information to
each host.
10.2.15 Passive Interface
The passive interface which is configured by OSPF network operate as stub area. There-
fore passive interface can not exchange the OSPF routing information.
To configure the passive interface, use the following command.
Command Mode Description
passive-interface INTERFACE
[A.B.C.D]
Router Configures the passive interface.
To release the configured as passive interface, use the following command.
Command Mode Description
no passive-interface INTERFACE
[A.B.C.D]
Router Releases the configured as passive interface.