Siemens S223 - Manual (Page 56)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
56 A50010-Y3-C150-2-7619
[Sample Configuration 2] Configuration TACACS+ server
The following is an example of configuring authorization method as TACACS+.
SWITCH(config)# user add user test1
Changing password for user
Enter the new password (minimum of 5, maximum of 8 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:vertex
Re-enter new password:vertex
Password changed.
SWITCH(config)# login local tacacs enable
SWITCH(config)# login remote tacacs enable
SWITCH(config)# login local tacacs primary
SWITCH(config)# login remote tacacs primary
SWITCH(config)# login tacacs server add 200.1.1.1 1
SWITCH(config)# login tacacs interface default
SWITCH(config)# login tacacs socket-port 1
SWITCH(config)# login tacacs auth-type pap
SWITCH(config)# login tacacs timeout 10
SWITCH(config)# login tacacs priority-level root
SWITCH(config)# show login
[AUTHEN]
Local login : tacacs host
Remote login : tacacs host
Accounting mode : both
------------------------------------
[HOST]
maximum_login_counts : 8
------------------------------------
[RADIUS]
Radius Retries : 3
Radius Timeout : 3
Radius Interface : default
------------------------------------
[TACACS]
200.1.1.1 1
Tacacs Timeout : 10
Tacacs Socket Port : 1
Tacacs Interface : default
Tacacs PPP Id : 1
Tacacs Authen Type : PAP
Tacacs Priority Level : MAX(ROOT)
SWITCH(config)#
4.3 Assigning IP Address
The switch uses only the data’s MAC address to determine where traffic needs to come
from and which ports should receive the data. Switches do not need IP addresses to
transmit packets. However, if you want to access to the hiD 6615 S223/S323 from remote
Displayed according to the priority