Siemens S223 - Manual (Page 31)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 31
Tab. 3.4 shows a couple of main commands of Bridge Configuration mode.
Command Description
auto-reset Configures the system for automatic rebooting
dhcp-server-filter Configures packet filtering of DHCP server.
erp Configures ERP function
lacp Configures LACP function.
lldp Configures LLDP function
mac Manages MAC address
mac-flood-guard Configures mac-flood-guard.
mirror Configures mirroring function.
oam Configures EFM-OAM protocol
port Sets port configuration
stp Configures Spanning Tree Protocol
trunk Configures trunk-function.
vlan Configures VLAN function.
Tab. 3.4 Main Commands of Bridge Configuration Mode
3.1.5 Rule Configuration Mode
You can open Rule Configuration mode using the command, rule NAME create, on
Global Configuration
mode.
If you open Rule Configuration mode, the system prompt is changed from
SWITCH(config)# to SWITCH(config-rule[name])#.
Command Mode Description
rule NAME create Global Opens Rule Configuration mode.
On the Rule Configuration mode, it is possible to configure the condition and operational
method for the packets to which the rule function is applied.
Tab. 3.5 shows a couple of important main commands of Rule Configuration mode.
Command Description
apply Configures rule configuration and applies it to the switch.
mac Configures a packet condition by MAC address.
match Configures an operational condition which meets the packet condition.
port Configures a packet condition by port number.
priority Configures the priority for rule.
vlan Configures VLAN.
Tab. 3.5 Main Commands of Rule Configuration Mode