Siemens S223 - Manual (Page 181)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 181
8.1.1.5 Displaying VLAN
To display a configuration of VLAN, use the following command.
Command Mode Description
show vlan [VLANS]
Enable
Global
Bridge
Shows the configuration for specific VLAN, enter VLAN
ID.
8.1.2 Protocol-Based VLAN
User can use a VLAN mapping that associates a set of processes within stations to a
VLAN rather than the stations themselves. Consider a network comprising devices sup-
porting multiple protocol suites. Each device may have an IP protocol stack, an AppleTalk
protocol stack, an IPX protocol stack and so on.
If we configure VLAN-aware switches such that they can associate a frame with a VLAN
based on a combination of the station’s MAC source address and the protocol stack in
use, we can create separate VLANs for each set of protocol-specific applications.
To configure protocol-based VLAN, follow these steps.
1. Configure VLAN groups for the protocols you want to use.
2. Create a protocol group for each of the protocols you want to assign to a VLAN.
3. Then map the protocol for each interface to the appropriate VLAN
Command Mode Description
vlan pvid PORTS [ethertype
ETHERTYPE ] <1-4094>
Configures protocol based VLAN.
PORTS: input a port number
ETHERTYPE: 0x800
1-4094: Vlan ID
no vlan pvid PORTS ethertype
[ETHERTYPE]
Bridge
Removes protocol based VLAN.
Because Protocol Based VLAN and normal VLAN run at the same time, Protocol Based
VLAN operates only matched situation comparing below two cases.
1. When Untagged Frame comes in and matches with Protocol VLAN Table, tags PVID
which configured on Protocol VLAN. But in no matched situation, tags PVID which
configured on and operates VLAN.
2. When Tagged Frame comes in and VID is 0, it switches by Protocol VLAN Table. But
if VID is not 0, it switches by normal VLAN Table.
8.1.3 MAC address-based VLAN
In order to configure VLAN based on MAC address, user should designate MAC address.
use the following command.