Siemens S223 - Manual (Page 38)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
38 A50010-Y3-C150-2-7619
After using these commands in order: show clock → configure terminal → interface 1
→ exit, press the arrow key <↑> and then you will see the commands from latest one:
exit
→ interface 1 → configure terminal → show clock.
SWITCHconfig)# exit
SWITCH# show clock
Mon, 5 Jan 1970 23:50:12 GMT+0000
SWITCH# configure terminal
SWITCH(config)# interface 1
SWITCH(config-if)# exit
SWITCH(config)# exit
SWITCH# (press the arow key ↑)
↓
SWITCH# exit (arrow key ↑)
↓
SWITCH# interface 1 (arrow key ↑)
↓
SWITCH# configure terminal (arrow key ↑)
↓
SWITCH# show clock (arrow key ↑)
The hiD 6615 S223/S323 also provides the command that shows the commands used
before up to 100 lines.
Command Mode Description
show history Enable Shows a command history.
3.2.3 Using Abbreviation
Most of the commands can be used also with abbreviated form. The following table
shows some examples of abbreviated commands.
Command Abbreviation
clock cl
exit ex
show sh
configure terminal con te
Tab. 3.13 Command Abbreviation
3.2.4 Using Command of Privileged EXEC Enable Mode
You can execute the commands of Privileged EXEC Enable mode as show, ping, telnet,
traceroute
, and so on regardless of which mode you are located on.
To execute the commands of Privileged EXEC Enable mode on another mode, use the
following command.
Command Mode Description
do COMMAND All Executes the commands of Privileged EXEC mode.