Siemens S223 - Manual (Page 40)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
40 A50010-Y3-C150-2-7619
4 System Connection and IP Address
4.1 System Connection
After installing switch, the hiD 6615 S223/S323 is supposed to examine that each port is
rightly connected to network and management PC. And then, user connects to system to
configure and manage the hiD 6615 S223/S323. This section provides instructions how to
change password for system connection, connect to system through telnet as the follow-
ing order.
•
System Login
• Password for Privileged EXEC Mode
• Changing Login Password
• Management for System Account
• Limiting Number of User
• Telnet Access
• Auto Log-out
• System Rebooting
4.1.1 System Login
After installing the hiD 6615 S223/S323, finally make sure that each port is correctly con-
nected to PC for network and management. And then, turn on the power and boot the
system as follow.
Step 1
When you turn on the switch, booting will be automatically started and login prompt will
be displayed.
SWITCH login:
Step 2
When you enter login ID at the login prompt, password prompt will be displayed. And en-
ter password to open Privileged EXEC View mode. By default setting, login ID is config-
ured as admin and it is possible to access without password.
SWITCH login: admin
Password:
SWITCH>
Step 3
In Privileged EXEC View mode, you can check only the configuration for the switch. To
configure and manage the switch, you should begin Privileged EXEC Enable mode. The
following is an example of beginning Privileged EXEC Enable mode.
SWITCH> enable
SWITCH#