Siemens S223 - Manual (Page 52)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
52 A50010-Y3-C150-2-7619
4.2.4.4 Frequency of Retransmit
If there is no response from RADIUS server, the hiD 6615 S223/S323 is supposed to re-
transmit an authentication request. To set the frequency of retransmitting an authentica-
tion request, use the following command.
Command Mode Description
login radius retransmit <1-10> Global
Sets the frequency of retransmit.
1-10: Enters the times of retry (default: 3)
4.2.5 TACACS Server
4.2.5.1 TACACS Server for System Authentication
To add/delete the TACACS server for system authentication, use the following command.
Command Mode Description
login tacacs server A.B.C.D KEY
Adds the TACACS server with its information.
A.B.C.D: IP address
KEY: authentication key value
no login tacacs server A.B.C.D
Global
Deletes an added TACACS server.
A.B.C.D: IP address
You can add up to 5 TACACS servers.
After adding the TACACS server, you should register interface of TACACS server con-
nected to user’s switch. Use the following command.
Command Mode Description
login tacacs interface NAME
A.B.C.D
Registers interface of TACACS server connected to
user’s switch.
no login tacacs interface
Global
Clears TACACS server interface
4.2.5.2 TACACS Server Priority
To specify the priority of a registered TACACS server, use the following command.
Command Mode Description
login tacacs server move
A.B.C.D <1-5>
Global
Specifies the priority of RADIUS server.
A.B.C.D: TACACS server address
1-5: the priority of TACACS server
4.2.5.3 Timeout of Authentication Request
After the authentication request, the hiD 6615 S223/S323 waits for the response from the
TACACS server for specified time.
i