6 ospf area, 1 area authentication, Ospf area – Siemens S223 User Manual
Page 342
UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
342 A50010-Y3-C150-2-7619
To delete a configured router communicated by non-broadcast type, use the following
command.
Command Mode
Description
no neighbor
A.B.C.D cost [<1-65535>]
no neighbor
A.B.C.D priority [<0-255>]
no neighbor
A.B.C.D priority poll-interval [<1-
65535>]
no neighbor
A.B.C.D poll-interval [<1-65535>]
no neighbor
A.B.C.D poll-interval priority [<0-
255>]
Router
Deletes a configured neighbor router of
NBMA type.
10.2.6 OSPF
Area
Router configuration on OSPF network includes Area configuration with each interface,
network. Area has various and special features. It needs to be configured pertinently to
make effective management on whole of OSPF network.
OSPF network defines several router types to manage the Area. ABR (Area Border
Router) is one of the router types to transmit information between Areas.
ASBR (Autonomous System Border Router) is using OSPF on oneside and using other
routing protocol except for OSPF on other interface or Area. ASBR exchanges area in-
formation between different routing protocols.
Area types are various. The most principle Area types are Stub Area and NSSA (Not So
Stubby Area).
10.2.6.1 Area
Authentication
OSPF routers in specific Area can configure authentication for security of routing informa-
tion. Encoding uses password based on text or MD5. To set password on interface as-
signed Area, use the ip ospf authentication-key and ip ospf message-digest-key
commands in interface mode, see Section 10.2.4.1 for more information.
To configure authentication information for encoding, use the following command.
Command Mode
Description
area
<0-4294967295> authenti-
cation
Configures authentication information which is based
on text encoding in the Area.
area
<0-4294967295> authenti-
cation
message-digest
Router
Configures authentication information which is based
on MD5 encoding in the Area.
To delete configured authentication information for encoding, use the following command.
Command Mode
Description
no area
<0-4294967295> authen-
tication
Router
Deletes configured authentication information.