beautypg.com

7 self loop detection – Siemens S223 User Manual

Page 223

background image

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5

A50010-Y3-C150-2-7619 223

To configure BPDU guard in the switch, perform the following procedure.

Step 1
Configure the specific port as edge-port.

Command Mode

Description

stp edge-port PORTS

Configures the port as Edge port.

no stp edge-port PORTS

Bridge

Disables Edge port configuration.

Step 2
Configure BPDU Guard.

Command Mode

Description

stp bpdu-guard

Configures BPDU Guard function on switch.

no stp bpdu-guard

Bridge

Disables BPDU Guard function.

However, BPDU Guard can be corrupted by unexpected cause. In this case, the edge
port is blocked immediately and remains at this state until user recovers it. To prevent this
problem, the hiD 6615 S223/S323 switch provides BPDU guard auto-recovery function.
When an edge port is down for BPDU packet which came from other switch, the port is
recovered automatically after configured time.

To configure BPDU Guard auto-recovery, use the following command.

Command Mode

Description

stp bpdu-guard auto-recovery

Configures BPDU Guard auto-recovery on switch.

stp bpdu-guard auto-recovery-

time

<10-1000000>

Configures BPDU Guard auto-recovery-time.

no stp bpdu-guard auto-

recovery

no stp bpdu-guard auto-

recovery-time

Bridge

Disables BPDU Guard auto-recovery function.

To recover a blocked port by manually, use the following command.

Command Mode

Description

stp bpdu-guard err-recovery

PORTS

Bridge

Recovers a blocked port by manually.

8.3.9.7

Self Loop Detection

Although there is no double path in user’s equipment, loop can be caused by network en-
vironment and cable condition connected to equipment. To prevent this, the hiD 6615
S223/S323 has self loop detection to perceive that outgoing packet is got back. Through
the self loop detection, you can prevent packet, which comes back because it blocks the
port.

This manual is related to the following products: