Siemens S223 - Manual (Page 120)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
120 A50010-Y3-C150-2-7619
7.2.2 Local OAM Mode
To configure Local OAM, use the following command.
Command Mode Description
oam local mode {active |
passive } PORTS
Bridge Configures the mode of local OAM.
Both request and loopback are possible for local OAM active. However, request or loop-
back is impossible for local OAM passive.
7.2.3 OAM Unidirection
When RX is impossible in local OAM, it is possible to send the information by using TX.
To enable/disable the function, use the following command.
Command Mode Description
oam local unidirection enable
PORTS
Sends the information by using TX.
oam local unidirection disable
PORTS
Bridge
Disables to transmit the information by using TX.
7.2.4 Remote OAM
To enable/disable remote OAM, use the following command.
Command Mode Description
oam remote oam admin <1-2>
enable PORTS
Enables remote OAM.
oam remote oam admin <1-2>
disable PORTS
Bridge
Disables remote OAM.
To configure the mode of remote OAM, use the following command.
Command Mode Description
oam remote oam mode <1-2>
{active | passive} PORTS
Bridge Configures the mode of remote OAM.
i