Siemens S223 - Manual (Page 57)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 57
place with TCP/IP through SNMP or telnet, it requires IP address.
You can enable interface to communicate with switch interface on network and assign IP
address as the following:
•
Enabling Interface
• Disabling Interface
• Assigning IP Address to Network Interface
• Static Route and Default Gateway
• Displaying Forwarding Information Base(FIB) Table
• Forwarding Information Base(FIB) Retain
• Displaying Interface
• Sample Configuration
4.3.1 Enabling Interface
To assign an IP address to an interface, you need to enable the interface first. If the inter-
face is not enabled, you cannot access it from a remote place, even though an IP address
has been assigned.
To display if interface is enabled, use the command, show running-config.
Interface Configuration Mode
To open Interface Configuration mode of the interface you are about to enable interface,
use the following command.
Command Mode Description
interface INTERFACE Global Opens Interface Configuration mode of the interface.
To enable the interface, use the following command.
Command Mode Description
no shutdown Interface Enables the interface on Interface Configuration mode.
The following is an example of enabling interface on Interface Configuration mode.
SWITCH# configure terminal
SWITCH(config)# interface 1
SWITCH(config-if)# no shutdown
SWITCH(config-if)#
4.3.2 Disabling Interface
To disable the interface, use the following commands on Interface Configuration mode.
Before disabling interface on Interface Configuration mode, you should open the mode,
and then use the follow command.
Command Mode Description
shutdown Interface Disables an interface on Interface Configuration mode.