Siemens SIMATIC TIWAY 1 User Manual
Simatic tiway 1 unilink host adapter
Table of contents
Document Outline
- TITLE
- 1 THE UNILINK HOST ADAPTER
- 2 OPERATION AND APPLICATION
- 2.1 INTRODUCTION
- 2.2 COMMAND PROCESSING
- 2.3 FUNCTIONAL ORGANIZATION AND OPERATING MODES
- 2.4 TIWAY I HOST SOFTWARE SUPPORT
- 2.5 SETTING THE OPERATING MODE
- 2.6 SPECIAL NETWORK MANAGER FEATURES
- 2.7 THE HIU AS A SECONDARY
- 2.8 MODE INDEPENDENT OPERATIONS
- 2.9 BASIC NETWORK OPERATIONS
- 2.10 EXTENDED NETWORK OPERATIONS
- 2.10.1 What Are Macros?
- 2.10.2 The Parts of a Macro
- 2.10.3 The Macro Commands
- 2.10.4 Setting Up A Macro
- 2.10.5 Checking The Macro Response and Macro Status
- 2.10.6 Enabling and Disabling Macros
- 2.10.7 Initializing the Macro Response Buffer
- 2.10.8 Checking Memory Usage
- 2.10.9 Linking Macros
- 2.10.10 Network Performance
- 3 CONFIGURING THE HOST COMPUTER PORT
- 4 THE TIWAY I NETWORK PORTS
- 5 HOST COMMAND SET REFERENCE
- 5.1 INTRODUCTION
- 5.2 ERROR RESPONSE
- 5.3 BASE HIU COMMANDS
- 5.4 THE EXTENDED HIU COMMANDS
- 5.4.1 Allocate Source Id -- 10
- 5.4.2 Configure HIU Command -- 11
- 5.4.3 Report HIU Configuration -- 12
- 5.4.4 Allocate Macro Storage Buffers -- 13
- 5.4.5 Define Macro -- 14
- 5.4.6 Gather Macro Response -- 15
- 5.4.7 Enable/Disable Macro Execution -- 16
- 5.4.8 Initialize Macro Response Buffer -- 17
- 5.4.9 Report Memory Usage -- 18
- 5.4.10 Allocate HIU Bandwidth -- 19
- 5.4.11 Report HIU Bandwidth Allocation -- 1A
- 5.4.12 Report HIU Status -- 1B
- 5.4.13 Link Macro -- 1C
- 5.5 ADAPTER CONFIGURATION COMMANDS
- 5.6 NETWORK MANAGER COMMANDS
- 5.6.1 Configure Network Manager -- 30
- 5.6.2 Report Network Manager Configuration -- 31
- 5.6.3 Report Secondary Link Status -- 32
- 5.6.4 Switch Channel -- 33
- 5.6.5 Allocate Network Manager Buffers -- 34
- 5.6.6 Report Network Manager Buffers Available -- 35
- 5.6.7 Report Network Bandwidth Allocation -- 36
- 5.6.8 Report Network Manager Secondary Statistics -- 37
- 5.6.9 Report Network Manager Network Statistics -- 38
- 5.7 MODE INDEPENDENT COMMANDS
- 5.8 COMMAND SYNTAX QUICK REFERENCE
- 5.9 COMMAND CODES REFERENCE (NUMERICAL ORDER)
- 5.10 COMMAND CODES REFERENCE (BY FUNCTION)
- 6 ERROR CODES AND DIAGNOSTICS
- A USING THE NON-INTELLIGENT TERMINAL PROTOCOL
- B USING THE BDLC PROTOCOL
- C NOT AVAILABLE IN ELECTRONIC FORM
- D NOT AVAILABLE IN ELECTRONIC FORM
- E CONFIGURATION WORKSHEET
- F MACRO DEFINITIONS FORM