Siemens S223 - Manual (Page 337)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 337
To configure an authentication key which is based on MD5 encoding, use the following
command.
Command Mode Description
ip ospf message-digest-key <1-
255> md5 KEY [active]
ip ospf message-digest-key <1-
255> md5 [active]
ip ospf A.B.C.D message-digest-
key <1-255> md5 [active]
ip ospf A.B.C.D message-digest-
key <1-255> md5 LINE [active]
ip ospf A.B.C.D message-digest-
key <1-255> md5 KEY [active]
Interface
Configures the authentication which is based on md5
type.
1-255: key ID
KEY: maximum 16 alphanumeric characters
To delete a configured authentication key, use the following command.
Command Mode Description
no ip ospf authentication-key
KEY
no ip ospf authentication-key
KEY {first | second}
no ip ospf A.B.C.D authentica-
tion-key KEY
no ip ospf A.B.C.D authentica-
tion-key KEY {first | second}
no ip ospf message-digest-key
<1-255>
no ip ospf A.B.C.D message-
digest-key <1-255>
Interface Deletes a configured authentication key.
10.2.4.3 Interface Cost
OSPF protocol assigns suitable cost according to the bandwidth on the each interface to
find the shortest route. Cost is used for packet routing, and routers are using the Cost to
communicate.
To configure an interface cost for OSPF, use the following command.
Command Mode Description
ip ospf cost <1-65535>
ip ospf A.B.C.D cost <1-65535>
Interface Configures an interface cost for OSPF.