Siemens S223 - Manual (Page 314)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
314 A50010-Y3-C150-2-7619
When the Register message is transmitted, the range of Checksum in header conforms to
header part as RFC standard, but whole packet is included in the range of checksum in
case of Cisco router. For compatibility with Cisco router, you should configure the range
of Checksum of Register message as whole packet.
To configure the range of Checksum of Register message as whole packet for compatibil-
ity with Cisco router, use the following command.
Command Mode Description
ip pim cisco-register-checksum
Configures the option to calculate the Register check-
sum over the whole packet.
ip pim cisco-register-checksum
group-list {<1-99> | <1300-1999>
| ACCESS-LIST}
Global
Configures the option to calculate the Register check-
sum over the whole packet on multicast group speci-
fied by the access list.
1-99: simple access-list
1300-1999: simple access list (extended range)
ACCESS-LIST: IP named standard access list
To delete a configured Cisco-compatible checksum option, use the following command.
Command Mode Description
no ip pim cisco-register-
checksum
Global Deletes a configured value.
This command is disabled by default. And Register Checksum is calculated only over the
header by default.
9.3.8.2 Candidate RP Message with Cisco BSR
Cisco’s BSR code does not conform to the latest BSR draft, it does not accept candidate
RPs with a group prefix number of zero. To make the hiD 6615 S323 candidate RP work
with a Cisco BSR, use the following command. This command is used to inter-operate
with older Cisco IOS versions.
Command Mode Description
ip pim crp-cisco-prefix
Configure the Candidate RP-Message to work with
Cisco BSR
no ip pim crp-cisco-prefix
Global
Return to the default setting
9.3.8.3 Excluding GenID Option
To exclude the GenID option from Hello packets on particular interface for inter-operation
with older Cisco IOS versions, use the following command
Command Mode Description
ip pim exclude-genid Excludes the GenID from hello packets.
no ip pim exclude-genid
Interface
Returns to the default setting.
i