beautypg.com

Siemens S223 User Manual

Page 162

background image

UMN:CLI User Manual

SURPASS hiD 6615 S223/S323 R1.5

162 A50010-Y3-C150-2-7619

To remove registered dynamic MAC addresses from the MAC table, use the following
command.

Command Mode

Description

clear mac

Clears dynamic MAC addresses.

clear mac

NAME

Clears dynamic MAC addresses.

clear mac

NAME PORT

Clears dynamic MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.

clear mac

NAME PORT

MACADDR

Enable

Global
Bridge

Clears dynamic MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.
MACADDR: enter the MAC address.

To remove static MAC addresses manually registered by user from the MAC table, use
the following command.

Command Mode

Description

no mac

Deletes static MAC addresses.

no mac

NAME

Deletes static MAC addresses, enter the bridge name.

no mac

NAME PORT

Deletes static MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.

no mac

NAME PORT MACADDR

Bridge

Deletes a specified static MAC address.
NAME: enter the bridge name.
PORT: enter the port number.
MACADDR: enter the MAC address.

To display a MAC table in the switch, use the following command.

Command Mode

Description

show mac NAME

[PORT]

Enable

Global
Bridge

Shows switch MAC address, selection by port number
(subscriber port only):
NAME: enter the bridge name
PORT: select the port number.

There are more than a thousand of MAC addresses in MAC table. And it is difficult to find
information you need at one sight. So, the system shows certain amount of addresses
displaying –more– on standby status. Press any key to search more. After you find the in-
formation, you can go back to the system prompt without displaying the other table by
pressing <q>.

i

This manual is related to the following products: