Siemens S223 - Manual (Page 281)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 281
9.1.4 Displaying MRIB Information
To display MRIB information, use the following commands
Command Mode Description
show ip mroute {dense | sparse}
{count | summary}
show ip mroute GROUP-ADDR
[SRC-IP-ADDRESS] {dense |
sparse } {count | summary}
show ip mroute GROUP-ADDR
[SRC-IP-ADDRESS] GROUP-
ADDR [SRC-IP-ADDRESS]{dense
| sparse} {count | summary}
show ip mroute GROUP-
ADDR /M {dense | sparse} {count
| summary}
Enable
Global
Bridge
Displays multicast routes entries.
GROUP-ADDR: group IP address
SRC-IP-ADDRESS: source IP address
To display the contents of the MRIB VIF table, use this command.
Command Mode Description
show ip mvif [IFNAME] Enable Displays IP multicast interface.
9.1.5 Multicast Time-To-Live Threshold
Use this command to configure the time-to-live (TTL) threshold of packets being for-
warded out of an interface.
Command Mode Description
ip multicast ttl-threshold
<0-255>
Configures the time-to-live threshold for multicast
packet
Default: 1
no ip multicast ttl-threshold
interface
Restores is as a default.
9.1.6 MRIB Debug
Use this command to debug events in the multicast RIB.
Command Mode Description
debug nsm mcast {all | fib-msg |
mrt | register | stats | vif}
Debugs event in the multicast RIB.
all : all Ipv4 multicast debugging
fib-msg: multicast FIB messages
mrt: multicast routes
register: multicast PIM register messages
stats: multicast statitics
vif: multicast interface
no debug nsm mcast {all | fib-
msg | mrt | register | stats | vif}
Enable
Disables the debug event.