Siemens S223 User Manual
Page 191
User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 191
---------------------------------------------------------------
| 1 2 3 4
Ethertype | VID |123456789012345678901234567890123456789012
---------------------------------------------------------------
0x0800 5 .p........................................
0x0900 6 ...p......................................
SWITCH(bridge)#
With above configuration, the packets from port number 2 and 4 are decided according to
the protocol. In case the protocol is incongruous, the route is decided according to the
port based VLAN.
[Sample Configuration 4] Configuring QinQ
10 port of SWITCH 1 and 11 port of SWITCH 2 are connected to the network where dif-
ferent VLANs are configured. To communicate without changing VLAN configuration of
SWITCH 1 and SWITCH 2 which communicate with PVID 10, configure it as follows.
You should configure the ports connected to network communicating with PVID 11 as
Tagged VLAN port.
< SWITCH 1 >
SWITCH(bridge)# vlan dot1q-tunnel enable 10
SWITCH(bridge)# vlan pvid 10 11
SWITCH(bridge)# show vlan dot1q-tunnel
Tag Protocol Id : 0x8100 (d: double-tagging port)
----------------------------------------------------
| 1 2 3 4
Port |123456789012345678901234567890123456789012
----------------------------------------------------
dtag .........d................................
SWITCH(bridge)#
< SWITCH 2 >
SWITCH(bridge)# vlan dot1q-tunnel enable 11
SWITCH(bridge)# vlan pvid 11 11
SWITCH(bridge)# show vlan dot1q-tunnel
Tag Protocol Id : 0x8100 (d: double-tagging port)
----------------------------------------------------
| 1 2 3 4
Port |123456789012345678901234567890123456789012
----------------------------------------------------
dtag ..........d...............................
SWITCH(bridge)#
[Sample Configuration 5] Configuring Shared VLAN with FID
Configure br2, br3, br4 in the hiD 6615 S223/S323 configured Layer 2 environment and
24 ports as Uplink port is configured. To transmit untagged packet through Uplink port
rightly, follow below configuration.
i