Siemens S223 - Manual (Page 335)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 335
Step 3
Use the network command to specify a network to operate with OSPF.
There are two ways to show network information configurations. Firstly, shows IP address
with bitmask like “10.0.0.0/8”. Secondly, shows IP address with wildcard bit information
like “10.0.0.0 0.0.0.255”. The variable option after area must be IP address or OSPF area
ID.
To configure a network, use the following command.
Command Mode Description
network A.B.C.D/M area {<0-
4294967295> | A.B.C.D}
network A.B.C.D A.B.C.D area
{<0-4294967295> | A.B.C.D}
Router
Specifies a network with OSPF area ID.
0-4294967295: OSPF area ID
10.2.2 ABR Type Configuration
The hiD 6615 S323 supports 4 types of OSPF ABR which are Cisco type ABR (RFC
3509), IBM type ABR (RFC 3509), IETF Draft type and RFC 2328 type.
To configure ABR type of OSPF, use the following command.
Command Mode Description
ospf abr-type {cisco | ibm |
shortcut | standard}
Selects an ABR type.
cisco: cisco type ABR, RFC 3509 (default)
ibm: IBM type ABR, RFC 3509
shortcut: IETF draft type
standard: RFC 2328 type
no ospf abr-type {cisco | ibm |
shortcut | standard}
Router
Deletes a configured ABR type.
10.2.3 Compatibility Support
OSPF protocol in the hiD 6615 S323 uses RFC 2328 which is finding shorten path. How-
ever, Compatibility configuration enables the switch to be compatible with a variety of
RFCs that deal with OSPF. Perform the following task to support many different features
within the OSPF protocol.
Use the following command to configure compatibility with RFC 1583.
Command Mode Description
compatible rfc1583 Supports compatibility with RFC 1583.
no compatible rfc1583
Router
Disables configured compatibility.
10.2.4 OSPF Interface
OSPF configuration can be changed. Users are not required to alter all of these parame-
ters, but some interface parameters must be consistent across all routers in an attached
network.