Siemens S223 - Manual (Page 30)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
30 A50010-Y3-C150-2-7619
Tab. 3.3 shows a couple of important main commands of Global Configuration mode.
Command Description
access-list Configures policy to limit routing information on the standard of AS.
arp Registers IP address and MAC address in ARP table.
bgp Helps BGP configuration.
bridge Opens Bridge Configuration mode.
copy Makes a backup file for the configuration of the switch.
dot1x Configures various functions of 802.1x daemon.
end Closes current mode and returns to User EXEC mode.
exit Closes current mode and returns to previous mode.
hostname Changes host name of the switch.
exec-timeout Configures auto-logout function.
fan Configures fan operation
interface Opens Interface Configuration mode.
ip Configures various functions of the interface.
passwd Changes a system password.
qos Configures QoS.
restore factory-defaults Restores the default configuration of the switch.
rmon-alarm Opens Rmon-alarm configuration mode.
rmon-event Opens Rmon-event configuration mode.
rmon-history Opens Rmon-history configuration mode.
route-map Opens Route-map Configuration mode.
router Opens Router Configuration mode.(OSPF. RIP, VRRP, PIM, BGP)
snmp Configures SNMP.
sntp Configures SNTP
syslog Configures syslog.
time-zone Configures time zone.
Tab. 3.3 Main Commands of Global Configuration Mode
3.1.4 Bridge Configuration Mode
In Bridge Configuration mode, you can configure various Layer 2 functions such as VLAN,
STP, LACP, EFM OAM, etc.
To open Bridge Configuration mode, enter the bridge command, then the system prompt
will be changed from SWITCH(config)# to SWITCH(bridge)#.
Command Mode Description
bridge Global Opens Bridge Configuration mode.