Siemens S223 - Manual (Page 33)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 33
3.1.8 Interface Configuration Mode
To open Interface Configuration mode, enter the command, interface INTERFACE, on
Global Configuration
mode, and then the prompt is changed from SWITCH(config)# to
SWITCH(config-if)#.
Command Mode Description
interface INTERFACE Global Opens Interface Configuration mode.
Interface Configuration mode is to assign IP address in Ethernet interface and to activate
or deactivate interface.
Tab. 3.8 shows a couple of main commands of Interface Configuration mode.
Command Description
bandwidth Configures bandwidth used to make routing information.
description Makes description of interface.
ip Assigns IP address.
shutdown Deactivates interface.
mtu Sets MTU value to interface.
Tab. 3.8 Main Commands of Interface Configuration Mode
3.1.9 RMON Configuration Mode
To open RMON-Alarm Configuration mode, enter rmon-alarm <1-65534>. To open
RMON-Event Configuration
mode, input rmon-event <1-65534>. And to open RMON-
History Configuration mode, enter rmon-history <1-65534>.
Tab. 3.9 shows a couple of important main commands of RMON Configuration mode.
Command Description
active Enables each RMON configuration.
community Configures password for trap message transmission right.
description Describes the RMON event.
falling-event
Configures to generate RMON alarm when object is less than config-
ured threshold.
falling-threshold Defines the falling threshold
owner
Shows the subject, which configures each RMON and uses related
information.
rising-event
Configures to generate RMON alarm when object is more than config-
ured threshold.
requested-buckets Defines a bucket count for the interval.
Tab. 3.9 Main Commands of RMON Configuration Mode