Siemens S223 - Manual (Page 234)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
234 A50010-Y3-C150-2-7619
Also, to make Preempt “enable” as default setting, use the following command on VRRP
configuration mode.
Command Mode Description
no preempt VRRP
Deletes the former configuration of Preempt to enable
it.
8.4.1.7 VRRP Statistics
To display the VRRP statistics that packets have been sent and received, use the follow-
ing command.
Command Mode Description
show vrrp stat
Enable
Global
Bridge
VRRP
Shows statistics of packets in Virtual Router Group.
The following is an example of viewing statistics of packets in Virtual Router Group.
SWITCH(config)# show vrrp stat
VRRP statistics :
VRRP packets rcvd with invalid TTL 0
VRRP packets rcvd with invalid version 0
VRRP packets rcvd with invalid VRID 0
VRRP packets rcvd with invalid size 0
VRRP packets rcvd with invalid checksum 0
VRRP packets rcvd with invalid auth-type 0
VRRP packets rcvd with interval mismatch 0
SWITCH(config)#
To clear the VRRP statistics information, use the following command.
Command Mode Description
clear vrrp stat
Enable
Global
Bridge
VRRP
Clears statistics of packets in Virtual Router Group.
8.5 Rate Limit
User can customize port bandwidth according to user’s environment. By this configuration,
you can prevent a certain port to monopolize whole bandwidth so that all ports can use
bandwidth equally. Egress and ingress can be configured both to be same and to be dif-
ferent.
The hiD 6615 S223/S323 can apply the rate limit and support ingress policing and egress
shaping.