Siemens S223 - Manual (Page 306)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
306 A50010-Y3-C150-2-7619
the DR.
9.3.1.3 Filters of Neighbor in PIM
Enable filtering of neighbors on the interface. When configuring a neighbor filter-PIM-SM
will either not establish adjacency with the neighbor, or terminate adjacency with the ex-
isting neighbors-if denied by filtering access list.
To configure the filtering of neighbor in PIM, use the following command.
Command Mode Description
ip pim neighbor-filter {<1-99> |
ACCESS-LIST }
Configures the filtering of neighbor in PIM.
1-99: simple access list
ACESS-LIST: IP named standard access list
no ip pim neighbor-filter {<1-99>
| ACCESS-LIST}
Interface
Disables the filtering configuration.
9.3.1.4 PIM Hello Query
To configure a query hold time, use the following command.
Command Mode Description
ip pim query-holdtime
<1-65535>
Configures the query hold time.
1-65535: hello message hold time (unit: second)
no ip pim query-holdtime
Interface
Disables the query hold time configuration.
When configuring query hold time, if the configured value is less than the current query
interval, it is refused.
To configure the frequency of hello interval value, use the following command.
Command Mode Description
ip pim query-interval <1-18724>
Configures the frequency of hello time.
1-18724: hello message interval (unit: second)
no ip pim query-interval
Interface
Disables the hello message interval configuration.