Siemens S223 - Manual (Page 334)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
334 A50010-Y3-C150-2-7619
Step1
Open Router Configuration mode from Global Configuration mode.
Command Mode Description
router ospf [<1-65535>] Opens Router Configuration mode with enabling OSPF.
no router ospf [<1-65535>]
Global
Disables OSPF routing protocol.
In case that more than 2 OSPF processes are operated, a process number should be as-
signed. Normally, there is one OSPF which is operating in one router.
If OSPF routing protocol is disabled, all related configuration will be lost.
Step2
Configure a network ID of OSPF. Network ID decides IP v4 address of this network.
Command Mode Description
router-id A.B.C.D Assigns a router ID with enabling OSPF.
no router-id A.B.C.D
Router
Deletes a configured router ID.
In case if using router-id command to apply new router ID on OSPF process, OSPF
process must be restarted to apply. Use the clear ip ospf process command to restart
OSPF process.
If there is changing router ID while OSPF process is operating, configuration must be
processed from the first. In this case, the hiD 6615 S323 can change only router ID with-
out changing related configurations.
Command Mode Description
ospf router-id A.B.C.D
Changes only a router ID without changing related
configurations.
no ospf router-id A.B.C.D
Router
Deletes a changed router ID.
To transfer above configuration to other routers, Use the clear ip ospf process com-
mand to restart OSPF process.
To display configured router-id, use the following command.
Command Mode Description
show router-id
Enable
Global
Bridge Displays configured router ID
!
i