Siemens S223 - Manual (Page 279)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 279
ing and PIM-SM should be configured at the same time.
hiX 5430
More than one port
on same interface
Layer 3 Network
Multicast Server
PIM-SM
Set-top Box
Set-top Box
Multicast data
IGMP Join/Leave
message
IGMP Snooping
Fig. 9.3 IGMP Snooping and PIM-SM Configuration Network
9.1 Multicast Routing Information Base
In this chapter, you can configure the common multicast commands for multicast routing
information base.
9.1.1 Enabling Multicast Routing (Required)
To provide multicast service on the hiD 6615 S323, you should use the ip multicast-
routing
command necessarily. If you disable the multicast routing, the multicast protocol
daemon remains present, but does not perform multicast functions.
Enable the multicast routing function, using the following command.
Command Mode Description
ip multicast-routing Enables multicast routing function.
no ip multicast-routing
Global
Disables multicast routing function. (default)
9.1.2 Limitation of MRIB Routing Entry
You can limit the number of multicast routes that can be added to a switch, and generate
an error message when the limit is exceeded.
To configure the limitation of MRIB routing entry, use the following command.
Command Mode Description
ip multicast route-limit LIMIT
[THRESHOLD]
Enables multicast routing function.
LIMIT: 1-214783647 (number of routes)
THRESHOLD: 1-214783647
no ip multicast route-limit
Global
Disables the limitation configuration of MRIB routing
entry.