Siemens S223 - Manual (Page 301)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 301
dropped, and the port is not allowed to receive IP multicast traffic from that group. If the
filtering action permits access to the multicast group, the IGMP report from the port is
forwarded for normal processing.
IGMP filtering controls only group specific query and membership reports, including join
and leave reports. It does not control general IGMP queries. IGMP filtering has no rela-
tionship with the function that directs the forwarding of IP multicast traffic.
9.2.8.1 Creating IGMP Profile
You can create or modify the IGMP profile to be used for filtering IGMP join requests from
a port. The system prompt will be changed to SWITCH(config-igmp-profile[N])# from
SWITCH(config)#.
Command Mode Description
ip igmp profile <1-2147483647> Global Configures IGMP profile.
To delete the created IGMP profile, use the no ip igmp profile <1-2147483647> com-
mand on global mode.
To display the IGMP profile, use the following command.
Command Mode Description
show ip igmp profile [<1-2147483647>]
Enable
Global
Bridge Shows IGMP profile.
9.2.8.2 Policy of IGMP Profile
Configure the action to permit or deny access to the IP multicast address using the follow-
ing command.
Command Mode Description
{permit | deny}
IGMP
Profile
Configures the action of IGMP profile.
9.2.8.3 Group Range of IGMP Profile
Configure the group range of IGMP Profile using the following command.
Command Mode Description
range A.B.C.D [A.B.C.D]
Configures a group range.
A.B.C.D: low IP multicast address
A.B.C.D: high IP multicast address
no range A.B.C.D [A.B.C.D]
IGMP
Profile
Deletes a configured group range.