Siemens S223 - Manual (Page 125)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 125
7.3.6 Displaying LLDP Configuration
To display LLDP configuration, use the following command.
Command Mode Description
show lldp config PORTS Shows LLDP configuration.
show lldp remote PORTS Show statistics for remote entries.
show lldp statistics PORTS
Enable
Global
Bridge
Shows LLDP operation and statistics.
To delete an accumulated statistics on the port, use the following command.
Command Mode Description
clear lldp statistics PORTS
Global
Bridge
Deletes an accumulated statistics on the port.
The following is to configure to enable LLDP function on Bridge Configuration mode-
through port number 10 of the switch and operate it.
SWITCH(bridge)# show lldp config 10
GLOBL:
-----------------------------------------------------------------------
MsgTxInterval = 30
MsgTxHold = 4 => txTTL = 120
ReInitDelay = 2
TxDelay = 2
-----------------------------------------------------------------------
PORTS active adminStat|optTLVs
10: disable Tx<->Rx|0xf= PortDesc, SysName, SysDesc, SysCap
SWITCH(bridge)# lldp enable 10
SWITCH(bridge)# lldp disable 10 portdescription
SWITCH(bridge)# lldp adminstatus 10 tx_only
SWITCH(bridge)# lldp msg txinterval 50
SWITCH(bridge)# lldp msg txhold 8
SWITCH(bridge)# show lldp config 10
GLOBL:
-----------------------------------------------------------------------
MsgTxInterval = 50
MsgTxHold = 8 => txTTL = 400
ReInitDelay = 2
TxDelay = 2
-----------------------------------------------------------------------
PORTS active adminStat|optTLVs
10: enable Tx only |0xe= SysName, SysDesc, SysCap
SWITCH(bridge)#