Siemens S223 - Manual (Page 272)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
272 A50010-Y3-C150-2-7619
8.10.3 Disabling Stacking
To disable stacking, use the following command.
Command Mode Description
no stack Global Disables the stacking function
8.10.4 Displaying Stacking Status
Command Mode Description
show stack
Enable
Global
Shows a configuration of stacking
8.10.5 Accessing to Slave Switch from Master Switch
After configuring all stacking configurations, it is possible to configure and mange by ac-
cessing to Slave switch from Master switch.
To access to Slave switch from Mater switch, use the following command in Bridge con-
figuration mode.
Command Mode Description
rcommand NODE Global
Accesses to a slave switch.
NODE: node number
NODE means node ID from configuring stacking in Slave switch. If you input the above
command in Mater switch, Telnet connected to Slave switch is displayed and it is possible
to configure Slave switch using DSH command. If you use the exit command in Telnet,
the connection to Slave switch is down.
8.10.6 Sample Configuration
[Sample Configuration 1] Configuring Stacking
The following is a stacking configuration by designating SWITCH A as a master and
SWITCH B as a slave.
Manage with the same
IP address
Switch A
Master Switch
Switch B
Slave Switch
Step 1
Assign IP address in Interface configuration mode of Switch and enable interface using
“no shutdown” command. In order to enter into Interface configuration mode, you should