Siemens S223 - Manual (Page 324)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
324 A50010-Y3-C150-2-7619
• Restart Time
It’s the waiting time for the restarting of Neighboring router’s BGP process. Restart
time allows BGP process time to restart and implement the internal connection (The
session). However, if it’s not working properly, it is considered as the router stops op-
erating.
• Stalepath Time
After BGP process of Neighboring router is restarted, it holds the time until BGP up
dates the path information. In case that the information of BGP routes is not updated
until the stalepath time, the switch discards this BGP routes information.
To set restart time or stalepath time on Graceful Restarting algorithm, use the following
command.
Command Mode Description
bgp graceful-restart restart-time
<1-3600>
Sets the restart time of Graceful Restart configuration
in the unit of second.
1-3600: restart time (default: 120)
bgp graceful-restart stalepath-
time <1-3600>
Router
Sets the stalepath-time of Graceful Restart configura-
tion in the unit of second.
1-3600: stalepath time (default: 30)
If you don’t use Graceful Restart feature or want to return the default value for restart time
or stalepath time, use the following command.
Command Mode Description
no bgp graceful-restart restart-
time [<1-3600>]
Restores the default value for restart time.
no bgp graceful-restart sta-
lepath-time [<1-3600>]
Router
Restores the default value for stalepath time.
10.1.3 IP Address Family
The hiD 6615 S323 recently supports both unicast and multicast as address-family. Use
the following command in choosing either unicast or multicast to enter the Address-
Family Configuratio
n mode allowing configuration of address-family specific parameters.
Use the following command in order to enable address family routing process, which
open you in Address-Family Configuration mode.
Command Mode Description
address-family ipv4 [multicast |
unicast ]
Router
Opens the Address-Family Configuration mode to con-
figure sessions for IP v4 prefixes.
exit-address-family
Address-
Family
Exits to Router Configuration mode.