Siemens S223 - Manual (Page 282)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
282 A50010-Y3-C150-2-7619
9.1.7 Multicast Aging
L2 and L3 Join information about Multicast Group used to apply on the chipset without
Multicast Stream, which makes dissatisfaction for Maximum Multicast Entry. Multicast Ag-
ing is to optimize Multicast Entry management using Multicast L2 Aging. When Multicast
Stream comes in, L2 filtering port (igmp snooping, pim snooping) would be written on the
chip. In addition, verify the hitbit about Entry after the Aging time to reset the aging time or
delete Entry to manage the Multicast Entry efficiently.
To configure the multicast againg, use the following command.
Command Mode Description
ip mcfdb aging-time < 10-
21474830>
Configures Aging tiem for Multicast Stream
(Default:300sec)
ip mcfdb aging-limit <256-
65535>
Configures Maximun Multicast Stream for Aging
(Default:5000)
no ip mcfdb aging-time
no ip mcfdb aging-limit
Global
Restores it as a default
To delete Muticast Stream Entry that has done the Aging, use the following command.
Command Mode Description
clear ip mcfdb {vlan VLAN}
Deletes Multicast Stream Entry after Aging per vlan or
all
clear ip mcfdb vlan VLAN group
A.B.C.D source A.B.C.D
Global
Deletes Multicast Stream Entry after Aging per vlan or
group, source
To display about Againg information, use the following command.
Command Mode Description
show ip mcfdb
Displays L2 Aging information
(aging-time, aging-limit information)
show ip mcfdb aging-entry
{vlan VID | group A.B.C.D}
[mac-based | detail] Displays L2 Aging information
show ip mfib
{vlan VID | group A.B.C.D}
[detail]
Displays L3 Aging Entry information as Input interface
(RPF) and Output Interface
Detail: displays input/output Port for each interface
and user for each port
show ip mfib hidden
{reserved | dstuser}
Enable
Global
Bridge
Displays reserved information and destination user
information as a hidden command