Siemens S223 - Manual (Page 21)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 21
1.3 Document Convention
This guide uses the following conventions to convey instructions and information.
Information
This information symbol provides useful information when using commands to configure
and means reader take note. Notes contain helpful suggestions or references.
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury
or broke the equipment. Before you work on any equipment, be aware of the hazards in-
volved with electrical circuitry and be familiar with standard practices for preventing acci-
dents by making quick guide based on this guide.
1.4 Document Notation
The following table shows commands used in guide book. Please be aware of each
command to use them correctly.
Notation Description
a Commands you should use as is.
NAME, PROFILE, VALUE, … Variables for which you supply values.
PORTS For entry this variable, see Section 5.1.
[ ]
Commands or variables that appear within square brackets [ ] are
optional.
< > Range of number that you can use.
{ }
A choice of required keywords appears in braces { }. You must se-
lect one.
| Optional variables are separated by vertical bars |.
Tab. 1.2 Command Notation of Guide Book
1.5 CE Declaration of Conformity
The CE declaration of the product will be fulfilled if the construction and cabling is under-
taken in accordance with the manual and the documents listed there in, e.g. mounting in-
structions, cable lists where necessary account should be taken of project-specific docu-
ments.
Deviations from the specifications or unstipulated changes during construction, e.g. the
use of cable types with lower screening values can lead to violation of the CE require-
ments. In such case the conformity declaration is invalidated and the responsibility
passes to those who have caused the deviations.
i
!