Yaskawa MotionWorks IEC - Manual (Page 367)

PLCopenPlus Function Blocks for Motion Control 2013-04-13 359
Transferring Cam Files to an MPiec Controller
Cam files and other user data files can be stored on the controller. There
are several ways to load the files on the controller, including:
1. MotionWorks IEC Resource Dialog window. (MP2300Siec and
MP2310iec only)
2. Hardware Configuration Utilities Menu
3. Web Server Project Archive Page (firmware 2.2.1 or higher is
required for added functionality of adding user data files
individually.)
4. Write a PC application to send files to the controller using the HTTP
POST method.
Downloading with MotionWorks IEC
In MotionWorks IEC, launch the “Project Control Dialog” shown below.