Yaskawa MotionWorks IEC - Manual (Page 327)

PLCopenPlus Function Blocks for Motion Control 2013-04-13 319
app 340C 0204 Unable to reach the network for the EtherNet/IP server.
Common causes include: invalid remote server address,
invalid gateway, invalid subnet mask, or the Ethernet
network is not correctly configured.
app 340C 0205 Remote server rejected connection attempt. The remote
server may not be listening for connections or there may
be a firewall preventing the connection.
app 340C 0206 The Ethernet/IP client ran out of connection slot
resources. Reduce the number of concurrent client
connections.
app 340C 0302 Unable to connect to the Modbus TCP slave. Common
causes include: invalid Modbus TCP slave address, invalid
gateway, invalid subnet mask, or the Ethernet network is
not correctly configured.
app 340C 0303 There is no route to the Modbus TCP slave. Common
causes include: invalid Modbus TCP slave address, invalid
gateway, invalid subnet mask, or the Ethernet network is
not correctly configured.
app 340C 0304 Unable to reach the network for the Modbus TCP slave.
Common causes include: invalid Modbus TCP slave
address, invalid gateway, invalid subnet mask, or the
Ethernet network is not correctly configured.
app 340C 0305 Modbus TCP slave rejected connection attempt. The
Modbus TCP slave may not be listening for connections or
there may be a firewall preventing the connection.
app 340C 0306 The Modbus TCP master ran out of connection slot
resources. Reduce the number of concurrent slave
connections.
app 340C 1020 The controller battery voltage has dropped, indicating it
has failed or is about to fail. While the controller is
powered on, the battery should be replaced as soon as
possible or a prolonged power-down state will cause
various static data to be lost.
app 340C 1028 The driver parameter specified in the axis configuration
caused an exception
app 340C 1029 The driver parameter did not match the axis configuration
app 340C 1030 The configured axis count exceeded the allowable limit.
app 340C 1031 The axis count exceeded the allowable limit due to an
auto-detected axis.
app 340C 1033 Using an incompatible version of the PLCopenPlus
firmware function block library may result in controller
instability. Consequently, the PLC application will not be