HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 81)

HEIDENHAIN MANUALplus 620, CNC PILOT 620/640
81
2.4 Units—Centr
ic dr
illing
"Boring, centric countersinking" unit
The unit uses stationary tools to drill axial holes in several passes.
Unit name: G72_CENTR / Cycle: G72 (see page 317)
Cycle form
NS
Starting block no. of contour
E Delay (dwell time at end of hole) (default: 0)
D Retraction at
 0: Rapid traverse
 1: Feed rate
RB Return plane
"Global" form
G14
Tool change point
 No axis
 0: Simultaneously
 1: First X, then Z
 2: First Z, then X
 3: Only X
 4: Only Z
 5: Y direction only
 6: Simultaneous with Y (X, Y and Z axes move on a
diagonal path)
CLT Coolant
 0: Without
 1: Circuit 1 on
 2: Circuit 2 on
SCK Safety clearance in infeed direction: Safety clearance in
infeed direction during drilling and milling operations.
G60 Protection zone. During drilling and boring the protection
zone monitoring is
 0: Active
 1: Inactive
Further forms:
see page 58