HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 40)

40
NC programming
1
.2 The smar
t.T
u
rn
edit
or
Shared menu items
The menu items described below are used both in smart.Turn mode
and in DIN/ISO mode.
"Program management" pull-down menu
The "Prog" pull-down menu (program management) contains the
following functions for NC main and subprograms:
 Open : Load existing programs
 New : Create new programs
 Close : The selected program is closed
 Close All
: All open programs are closed
 Save
: The selected program is saved
 Save As
: The selected program is saved under a new name
 Direct opening of the last four programs
When an NC program is opened or when a new NC program is
created, the soft-key row is switched to the sorting and organization
functions
. See "Sorting, file organization" on page 45..
"Head" pull-down menu (program head)
The "Head" pull-down menu (program head) contains functions for
editing the program head and the tool list.
 Program head : Edit the program head
 Go to chucking equipment : Positions the cursor in the "chucking
equipment" section
 Insert chucking equipment:
Describe how the workpiece is
clamped
 Go to tool list
: Positions the cursor in the TURRET section
 Set up the tool list
: Activates the "Set up tool list" function (see
page 53)
"ICP" pull-down menu
The "ICP" pull-down menu (Interactive Contour Programming)
contains the following functions:
 Contour editing
: Change the current contour (cursor position)
 Workpiece blank : Edit the description of the workpiece blank
 Finished part : Edit the description of the finished part
 New auxiliary blank : Create a new auxiliary workpiece blank
 New aux. contour : Create a new auxiliary contour
 C axis ...
: Create patterns and milling contours on the front face and
lateral surface
 Y axis ...
: Create patterns and milling contours in the XY and YZ
planes