HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 532)

532
TURN PLUS
7.
2 A
u
to
matic w
o
rk
ing plan g
e
ner
a
tion (A
WG)
Generating a working plan
Generating a working plan with TURN PLUS
Select "TURN PLUS." TURN PLUS opens the most recently selected
machining sequence.
Select "AWG." TURN PLUS shows the contours of the
blank and the finished part in the graphics window.
Press the "AWG control graphic" soft key: The AWG
control graphic and program generation are started.
Press the "Back" soft key to return to the TURN PLUS
menu.
Press the "Back" soft key to switch to smart.Turn.
Use the name of the current program without any
changes and press the "Save" soft key to overwrite
the current program.
Enter a name for the program and confirm with the
the "Save" soft key.
After
the working plan generation, consider the following:
If no chucking equipment has been defined in the program
as yet, TURN PLUS defines the chucking equipment for a
specific type of clamping/clamping length and adjusts the
cutting limitation accordingly. Adapt the values in the
finished NC program.