HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 566)

566
Overview of units
9.1 Units—"T
u
rn
ing" gr
oup
9.1 Units—"Turning" group
"Roughing" group
"Finishing" group
Unit Description Page
G810_ICP G810 Longitudinal in ICP
Roughing an ICP contour longitudinally
Page 65
G820_ICP G820 Transverse in ICP
Roughing an ICP contour transversely
Page 66
G830_ICP G830 Contour parallel in ICP
Roughing parallel to the contour in ICP
Page 67
G835_ICP G835 Bidirectional in ICP
Roughing an ICP contour in two directions
Page 68
G810_G80
G810 Longitudinal, direct
Longitudinal roughing with direct contour input
Page 69
G820_G80
G820 Transverse, direct
Transverse roughing with direct contour input
Page 70
Unit Description Page
G890_ICP
G890 Contouring in ICP
Finishing an ICP contour
Page 115
G890_G80_L G890 Contouring, direct longitdnl.
Longitudinal finishing with direct contour input
Page 117
G890_G80_P G890 Contouring, direct transverse
Transverse finishing with direct contour input
Page 118
G85x_DIN_E_F_G G890 Relief, type E, F, DIN76
Finishing the undercuts according to DIN509 type E and F and the thread
undercut DIN76
Page 119