New functions of software 548328-03 – HEIDENHAIN SW 548328-05 DIN Programming User Manual
Page 4
4
New functions of software 548328-03
The simulation function now also provides a 3-D view of the
workpiece blank and finished part. Workpieces can be depicted as a
solid-body model or transparent. The graphic can be both rotated
around the main axes and displayed in a three-quarter section view
(see the User’s Manual).
Simplified contour editing with ICP: When graphically supported
interactive contour description with ICP is active, contour-element
editing can now be selected directly by soft key (see the User’s
Manual).
Recessing with cut segmentation: Cut segmentation for recessing
depth is now available for the contour recessing cycle G860. (see
The parameters XA and ZA (starting point of blank) were added to
the roughing cycles G810, G820, G830 and G835. This makes it
possible to start the cutting process at any desired diameter of the
contour by entering a starting point. (see page 60)
Workpiece measurement: The Control now supports workpiece
measurement with touch probes. A sample cycle for measurement
of workpieces is available in the control. Additionally, the machine
manufacturers can offer specially developed measuring cycles that
are individually adapted to the machine series (see the User’s
Manual).
A speed limit that is only effective for the respective cycle can now
be defined for the parting cycle in Teach-in mode and smart.Turn
In the roughing and drilling cycles, an intermittent feed rate can now
be entered for chip breaking. (see page 60)
The approach angle and departure angle have been added to the ICP
cutting cycles. (see page 65)
The graphic window can now be activated automatically when the
cursor is located in the contour description. (see page 44)