HEIDENHAIN SW 548328-05 DIN Programming - Manual (Page 481)

HEIDENHAIN MANUALplus 620, CNC PILOT 620/640
481
6.2 Cont
ours in the XY plane
Circular arc in XY plane G172-Geo/G173-Geo
G172/G173 defines a circular arc in a contour of the XY plane. Direction
of rotation: See help graphic
Parameters
X End point (radius)
Y End point
R Radius
I Center in X direction (radius)
J Center in Y direction
Q Point of intersection. End point if the circular arc intersects a
line segment or another circular arc (default: 0):
 0: Near point of intersection
 1: Far point of intersection
BR Chamfer/rounding. Defines the transition to the next contour
element. When entering a chamfer/rounding, program the
theoretical end point.
 No entry: Tangential transition
 BR=0: No tangential transition
 BR>0: Rounding radius
 BR<0: Width of chamfer
Programming
 X, Y:
Absolute, incremental, modal or "?"
 I, J:
Absolute or incremental
 End point must not be the starting point (no full circle).